The Siren Board

Discussion of Outdoor Warning Systems
It is currently Sun Jun 16, 2019 8:21 pm

All times are UTC




Post new topic  Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Thu Jun 13, 2019 2:39 pm 
Offline
New User

Joined: Wed Jun 12, 2019 3:22 pm
Posts: 1
thanks in advance, i tried to reprogram a FS, FC control box, when i tried to read it, i got a run time error, and the program closed. i went to the 2nd siren and it read fine. retried the 1st one, same Error. any help ?? thanks


Top
   
PostPosted: Thu Jun 13, 2019 10:33 pm 
Offline
 

Joined: Sun Mar 06, 2016 3:56 pm
Posts: 30
Real Name: Keith Foor
Location: Johnstown, Ohio
I would try to reboot the controller, but barring that, test the local operation of teh siren and see if it works or if it's gone dumb. Also check the revision of the two controller boards. I saw a programmer the other day that had 3 different ports on it, if they have done something with the revision of the controller and either the cable or software is not right, that could possibly cause the issue as well.


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: 

Powered by phpBB® Forum Software © phpBB Limited