![Very Happy :D](./images/smilies/icon_e_biggrin.gif)
Ok, thanks! So I would just insert the wires, screw the wires into the positive and negative terminals on the green thingy and then it would work, right? Thank you again!Darley Champion wrote: ↑Mon Jan 01, 2024 7:17 amAh so it's one of those knockoff BG-12s, right?
If that's the case, then no, it's just a LED indicator board, this pull is conventional, you'd just need to wire it in series with the alarm you want to connect as if the pull was a light switch.
Hope that helps![]()
Ok thanks!Darley Champion wrote: ↑Mon Jan 01, 2024 11:15 pmUh yup, one positive goes into the pull station's normally common, the other positive wire (from the pull station to the alarm) goes from the NO (normally open) terminal in the pull to the alarm.
The negative wire, you just directly wire it up to the alarm.
That should get you going, assuming this pull has a single pole NO/NC switch.
Return to “Other Warning Systems - Indoor, Outdoor and Vehicular”
Users browsing this forum: No registered users and 1 guest